Tag: Bodywork
-
Build Session 36 : Repeaters, IVA, Mirrors, Wipers, Rear Hubs, Wings
Caterham 420R build session covering repeater lights, IVA preparation, mirrors, wipers, rear hubs, and wing work.
-
Build Session 35 : Front Wings, Handbrake Cable and Tidying Up
Caterham 420R build session covering front wing finishing, handbrake cable work, and general tidying before the final build stages.
-
Build Session 34 : Brake and Clutch Fillup/Bleed, Bonnet Collection and more Front Wings
Caterham 420R build session covering brake and clutch filling and bleeding, bonnet collection, and further front wing work.
-
Build Session 33 : Front Wings, Lights, Handbrake, Gearbox, Number Plate Light
Caterham 420R build session covering front wings, lighting, handbrake work, gearbox checks, and number plate light fitting.
-
Build Session 32 : LHS Indicators, Swap Wing Stays, Repeater Wiring
Caterham 420R build session covering left-hand indicator troubleshooting, swapped wing stays, and repeater wiring.
-
Build Session 30 : More Fuel and Washer Bottle Fitting
Caterham 420R build session covering further fuel-system work and washer bottle fitting.
-
Build Session 29 : Rear Wings
Caterham 420R build session fitting the rear wings and progressing the exterior bodywork.
-
Build Session 28 : Boot – Floor, Fuel Filler Shroud and Carpets
Caterham 420R build session covering boot-area assembly, including the floor, fuel filler shroud, and carpets.
-
Build Session 16 : Roll Over Bar, Some Engine Plumbing and Bonnet Test Fit with Nose Cone
Caterham 420R build session covering roll-over bar fitting, engine plumbing, and the first bonnet and nose-cone test fit.
-
Build Session 15 : Odds and Ends, Bonnet and Radiator
Caterham 420R build session covering miscellaneous tidy-up work, bonnet fitting, and radiator installation.