3D-printed cutaway model of the Project sEVen gearbox, showing coloured internal components, gears, shafts and bearings

2026-11 Gearbox Update

Posted

in

,

by

So… this is the first of a series of update blog posts. I haven't had the time to create videos, so blog posts it will have to be…

Some of you will have been on the last Zoom call and I covered things then. But a quick update. In July of 2025 I commissioned Compact Orbital Gears (COG) to develop me a 3.5:1 reduction transmission/gearbox to sit between my 24,000 RPM motor and a standard Seven differential. The motor and gearbox will sit in the transmission tunnel entrance. The transmission/gearbox is a planetary box, 3 planets, sun and ring gear. The input is on the sun gear, output from the planet carrier and the ring is stationary.

COG got 99% of the way through the design but the company ran into trouble (after 60 years) and went into receivership in March of this year. They’d gone very quiet on me since the start of the year. So I then spent a few months trying to get them to sign over the rights of the design to me, which they eventually did, and to get them to finish the design, which they didn’t. Once they finally went under and laid off the engineers that were working on my design, I engaged their lead engineer to finish off the design.

That gets us up to the last Caterham Club EV SIG zoom call (if you attend them).

Since then the engineer has finished the design and sent me the various files. I have a 3D model and about 30 PDF drawings that you’d need to actually make the design. The drawings cover things like surface finishes, tolerances, assembly order etc. Here's one of the drawings, but they cover all the components that need to be custom made along with assembly guides and general documentation.

Engineering drawing of the planet carrier assembly, showing exploded views, bearings, gears and cross-sections
Planet carrier assembly drawing, showing the components and assembly sequence.

So I’ve had a design and a set of drawings for the past month or so and I’ve been looking for a company to make it. I have one company that look like they can make the gears and some other hardened components and I’m searching around for companies that can make the remaining parts.

What is becoming clear is that COG had probably over-egged the pudding. I asked them at almost every call we had (most weeks while they existed) about whether there were simpler ways of doing the box. But they were adamant that all the extras were required. The lubrication and cooling system for instance. I'm sure a lot of the problem came down to my specification – I was asking for the box to support peak power, speed and longevity. The reality is that the car will very rarely hit those peaks and so could be significantly derated from the peaks. We absolutely did do that in the design process, but probably not enough. Soo….

Since touting the design around everyone is surprised at the complexity. They appreciate the quality of the work, but question whether it’s necessary. And of course they all suggest they could do a simpler job for a few tens of thousands of pounds. Some of the offers are tempting, but a) I don’t want to spend that sort of money and b) I’ve got over a year invested in this design now and I want to see it through.

The gearbox is still alive, but it still feels like there’s a lot of water still to flow under this bit of the project’s bridge.

And of course I had to 3D print a version. All looks good to me.

3D-printed cutaway model of the Project sEVen gearbox, showing coloured internal components, gears, shafts and bearings
The 3D-printed Project sEVen gearbox, with cutaways showing the internal components.

As always, questions welcome.

Comments

Leave a Comment