3D Models

  • Caterham 420R Front Right Scan

    Caterham 420R Front Right Scan

    Here’s a scan I’ve recently done of the front right of my 420R. It’s not water tight by any stretch of the imagination, but if you’re looking for something to show you where all the bits and pieces tie together, then this should be ok. Files: OBJ 3MF I find the 3MF files work best…

  • Caterham TIE ROD LEVER – PRE 2015

    Caterham TIE ROD LEVER – PRE 2015

    This steering arm was scanned as a request from UberNiche for a project he’s working on. In the end it was scanned by an Einscan HX  in structured-light mode. I tried using the Einstar but it struggled to get into the holes of the part. Scanning juice was used to try and fill in some…

  • Caterham Duratec S3 Engine Mount RHS

    Caterham Duratec S3 Engine Mount RHS

    This model was generated from a scan of the engine mount and modeled in Fusion 360.  NOTE: The engine mount I modeled had about a 1mm bulge in the engine plate which is not accounted for in the model. Link to Model OBJ

  • Caterham Duratec S3 Engine Mount LHS

    Caterham Duratec S3 Engine Mount LHS

    This model was generated from a scan of the engine mount and modeled in Fusion 360.  NOTE: The engine mount I modeled had about a 1mm bulge in the engine plate which is not accounted for in the model. Link to Model OBJ

  • Differential Trolley Plate

    Differential Trolley Plate

    Here’s a 3D model of the thing I attach to my trolley jack to allow me to lift a Caterham differential into the car by myself. Link to 3D Model OBJ

  • Differential Carrier 3D Model

    Differential Carrier 3D Model

    Here’s a 3D scan of my Caterham “BMW” Differential Carrier. Link to OBJ

  • BMW Differential

    BMW Differential

    Here’s my scan of the Caterham “BMW” differential.  Scanned using a Shining 3D Einstar. Link to OBJ