Author: John Martin
-
Caterham SV Nose Cone Scan
Post Views: 10 Well this one was a long time coming. I’d been wanting to scan my nose cone for ages. Mainly with the intention of modeling and printing a “bracket” for the number plate – which flaps around a bit on its velcro mount. But the first thing to do was get a scan. …
-
Putting the EV in sEVen – Progress #2 Strip Down and Weigh-in
Post Views: 21 Time for another EV progress video. In this quick video I cover the strip down of the project car to remove the Internal Combustion Engine (ICE) drivetrain. There’s also a couple of interludes where I visit: Fully Charged Show, Caterham Seven EV launch, Goodwood, the Taffia Fish and Chip Run and the…
-
SV Rear Top Scan
Post Views: 35 Here’s a scan of my 420R SV rear top. I did the scan mainly to capture the roll-over bar, but you may find other geometry interesting if you need it. This is a 2M triangle render, if you’d like higher resolution then send me an email or get in touch on socials.…
-
Caterham 420R Front Right Scan
Post Views: 33 Here’s a scan I’ve recently done of the front right of my 420R. It’s not water tight by any stretch of the imagination, but if you’re looking for something to show you where all the bits and pieces tie together, then this should be ok. Files: OBJ 3MF I find the 3MF…
-
Caterham TIE ROD LEVER – PRE 2015
Post Views: 14 This steering arm was scanned as a request from UberNiche for a project he’s working on. In the end it was scanned by an Einscan HX in structured-light mode. I tried using the Einstar but it struggled to get into the holes of the part. Scanning juice was used to try and…